DTF drying oven for A2-format
Prices are only visible after registration.
ART-NR:
DTF-OFEN-A2
Produktinformationen
Heating oven, for format goods up to 430 x 630 mm
- Usable area for gelling: 410 x 580 mm
- Digital temperature and time control
- Drying type: heating plate
- Teflon-coated fabric belt
Technical data:
Dimensions (WxDxH): 820 x 538 x 167 mm
Power: 1,600 watts
Power supply: 220 V
Guarantee:
The heating oven is covered by a 12-month bring-in service guarantee.
The heating oven is suitable for format goods up to 430 x 630 mm (gelling range of 410 x 580) and impresses with its optimised drying method.
Instead of a heat source from above (infrared rods / heating coils or similar), the DTF films are heated from below by using a heating plate,
The result is homogeneous, even gelling results.
A Teflon-coated fabric tape between the heating plate and the DTF film makes it easier to remove the material from the oven.
The control panel is intuitive to operate and allows precise setting of temperature and time.
When using ink, hot-melt adhesive granules and films from our range, the processing parameters for gelling are
range from 125 - 150 seconds, between 140°C and 165°C. The optimum processing parameters depend on the amount of ink applied,
print formats etc. and should be determined by you individually.
Available mid November 2024 DTF-OFEN-A2
- Usable area for gelling: 410 x 580 mm
- Digital temperature and time control
- Drying type: heating plate
- Teflon-coated fabric belt
Technical data:
Dimensions (WxDxH): 820 x 538 x 167 mm
Power: 1,600 watts
Power supply: 220 V
Guarantee:
The heating oven is covered by a 12-month bring-in service guarantee.
The heating oven is suitable for format goods up to 430 x 630 mm (gelling range of 410 x 580) and impresses with its optimised drying method.
Instead of a heat source from above (infrared rods / heating coils or similar), the DTF films are heated from below by using a heating plate,
The result is homogeneous, even gelling results.
A Teflon-coated fabric tape between the heating plate and the DTF film makes it easier to remove the material from the oven.
The control panel is intuitive to operate and allows precise setting of temperature and time.
When using ink, hot-melt adhesive granules and films from our range, the processing parameters for gelling are
range from 125 - 150 seconds, between 140°C and 165°C. The optimum processing parameters depend on the amount of ink applied,
print formats etc. and should be determined by you individually.
Available mid November 2024 DTF-OFEN-A2
Characteristics
| Dimension: | 820 x 538 x 167 mm |
|---|---|
| Power: | 1600 W |
| Power supply: | 220 V |
| Printable: | DTF drying oven |
| Print technology: | DTF ( Direct- to- Film) |
| Transfer surface: | 410 x 580 mm |
| Warranty: | 12- month on-site service |
Customers also viewed
